Thanks Bodhi. I'm still not sure why the environment variables I set as per step 8 didn't 'stick', but clearly I had loaded the image file as suggested. Looking at that file again, I can see that all those variables I mentioned as not being correct came from there. Oh well, a task for another day....
However, one problem you may know how to solve. If you look back at the envs in my last post, you will see that the mtdparts variable actually exists twice. Once at the top and then just after half-way down. Following your instructions, I modified it with fw_setenv to comply with your recommendation (orion_nand etc). When I then did a fw_printenv, I still had two entries - one had been corrected but the first was as before (nand_mtd). And try as I may, I just cannot get rid of both entries. If I try, only the second one (lower in the list) is deleted. The first (top) entry is still there. If I then edit and save the variable again - well, I get two again. The top one (nand_mtd) is never touched in any way! So how the **** can I get rid of it? I've tried from the NSA325> prompt as well as after a full boot - nothing works! I'm thinking I may have to repeat step 8 that deletes and resets all variables. Do you agree? Any comments gratefully received!!
Regards
Mike
However, one problem you may know how to solve. If you look back at the envs in my last post, you will see that the mtdparts variable actually exists twice. Once at the top and then just after half-way down. Following your instructions, I modified it with fw_setenv to comply with your recommendation (orion_nand etc). When I then did a fw_printenv, I still had two entries - one had been corrected but the first was as before (nand_mtd). And try as I may, I just cannot get rid of both entries. If I try, only the second one (lower in the list) is deleted. The first (top) entry is still there. If I then edit and save the variable again - well, I get two again. The top one (nand_mtd) is never touched in any way! So how the **** can I get rid of it? I've tried from the NSA325> prompt as well as after a full boot - nothing works! I'm thinking I may have to repeat step 8 that deletes and resets all variables. Do you agree? Any comments gratefully received!!
Regards
Mike